Do you have the opportunity to involve in the diagnosis a person providing maintenance on machinery.
I propose to start the diagnosis by inspecting the conveyor actuator. For this is necessary:
1. disconnect the crepe maker from the mains;
(photo 1)
2. remove the left cover of the crepe maker by unscrewing 4 screws fixing it (photo 1);
3. remove the "Start - Stop" handle by loosening its fastening to the stopper axis (2 set screws) (photo 1);
4. unscrew 4 screws securing the conveyor drive to the left inner wall of the crepe maker base (the screw heads are located near the conveyor coupling (photo 2, photo 3);
(photo 2)
(photo 3)
5. remove and inspect the conveyor actuator; pay attention to the condition of the microswitch rollers and the pressed thrust axle in the gear (photo 4). When removing the actuator, I recommend unscrewing the support leg of the crepe maker (one of the four, located directly under the drive attachment point) to the maximum.
(photo 4)